蓄热式燃烧炉RTO废气处理设备
来源:https://www.sdcjtz.com/ 发布时间:2023-05-23
蓄热式焚烧系统(RTO)是利用陶瓷蓄热体来储存有机废气分解时产生的热量,并用陶瓷蓄热体储存的热能来预热和分解未被处理的有机废气,从而达到很高的热效率,氧化温度一般在 800℃ 到 850℃ 之间,高可达1100℃。 蓄热式焚烧系统主要用于有机废气浓度较低而废气量较大的场合,在有机废气中含有腐蚀性、对催化剂有毒的物质和需要较高温度氧化某些臭气时也非常适用。
Regenerative incineration system (RTO) uses ceramic thermal storage to store the heat generated during the decomposition of organic waste gas, and uses the heat stored in ceramic thermal storage to preheat and decompose untreated organic waste gas, achieving high thermal efficiency. The oxidation temperature is generally between 800 ℃ and 850 ℃, up to 1100 ℃. The regenerative incineration system is mainly used in situations where the concentration of organic waste gas is low and the amount of waste gas is large. It is also very suitable when the organic waste gas contains corrosive and toxic substances to the catalyst, and when certain odors need to be oxidized at high temperatures.
二室RTO工作原理有机废气通过引风机输入蓄热室1进行升温,吸收蓄热体中存储的热量,随后进入焚烧室进一步燃烧,升温至设定的温度(760℃),在这个过程中有机成分被彻底分解为CO2和H2O。由于废气在蓄热室1内吸收了上一循环回收的热量,从而减少了燃料消耗。
The working principle of two chamber RTO is that organic waste gas is fed into the heat storage chamber 1 through an induced draft fan for heating, absorbing the heat stored in the heat storage body, and then enters the incineration chamber for further combustion. The temperature is raised to the set temperature (760 ℃), during which the organic components are completely decomposed into CO2 and H2O. Due to the exhaust gas absorbing the heat recovered from the previous cycle in regenerative chamber 1, fuel consumption is reduced.
处理过后的高温废气进入蓄热室2进行热交换,热量被蓄热体吸收,随后排放。而蓄热室2存储的热量将可用于下个循环对新输入的废气进行加热。该过程完成后系统自动切换进气和出气阀门改变废气流向,使有机废气经由蓄热室2进入,焚烧处理后由蓄热室1热交换后排放,如此交替切换持续运行。
The high-temperature exhaust gas after treatment enters the heat storage chamber 2 for heat exchange, and the heat is absorbed by the heat storage body before being discharged. The heat stored in regenerative chamber 2 will be used for heating the newly input exhaust gas in the next cycle. After the process is completed, the system automatically switches the inlet and outlet valves to change the flow direction of the exhaust gas, allowing the organic exhaust gas to enter through the heat storage chamber 2. After incineration treatment, it is discharged after heat exchange in the heat storage chamber 1. This alternating switch continues to operate.
实际上,RTO废气焚烧炉的温度使得废气被充分氧化和分解,以及所需的温度。它不是废物的一般着火点,因为它可以通过满足废气中的有害物质而完全分解,因此该温度非常高。该温度也是焚烧炉设计中的重要因素。
In fact, the temperature of the RTO waste gas incinerator allows the waste gas to be fully oxidized and decomposed, as well as the required temperature. It is not the general ignition point of waste, as it can completely decompose by meeting the harmful substances in the exhaust gas, so the temperature is very high. This temperature is also an important factor in the design of the incinerator.
它不仅提高了焚烧温度,而且有助于抑制焚烧过程中的黑烟。由于温度太高,燃料消耗是一个方面。另一方面,它增加了金属的挥发并增加了二氧化氯的含量,从而引起两种污染。所以请记住,焚烧的温度不能过高。
It not only increases the incineration temperature, but also helps to suppress black smoke during the incineration process. Due to the high temperature, fuel consumption is one aspect. On the other hand, it increases the volatilization of metals and increases the content of chlorine dioxide, resulting in two types of pollution. So please remember that the incineration temperature should not be too high.
厂家:RTO废气焚烧炉的温度与炉的废气之间存在密切关系,焚烧时间短,焚烧温度高。如果时间很长,则不需要太高。在初级焚烧室中,温度在800摄氏度和1100摄氏度之间。在两级焚烧室中,温度约为1200摄氏度。如果要处理氯化物类物质,则温度必须高于1200摄氏度,燃烧气体中的氧含量为6-12%。
Manufacturer: There is a close relationship between the temperature of the RTO waste gas incinerator and the exhaust gas from the furnace, with short incineration time and high incineration temperature. If the time is long, it does not need to be too high. In the primary incinerator, the temperature is between 800 degrees Celsius and 1100 degrees Celsius. In a two-stage incinerator, the temperature is approximately 1200 degrees Celsius. If chloride like substances are to be treated, the temperature must be above 1200 degrees Celsius, and the oxygen content in the combustion gas must be 6-12%.
本文由RTO废气处理设备友情奉献.更多有关的知识请点击:http://www.sdcjtz.com真诚的态度.为您提供为全面的服务.更多有关的知识我们将会陆续向大家奉献.敬请期待.
This article is a friendly contribution from RTO waste gas treatment equipment. For more relevant knowledge, please click on: http://www.sdcjtz.com Sincere attitude. We will provide you with comprehensive services. We will gradually contribute more relevant knowledge to everyone. Stay tuned
上一篇:机器人涂装线是一种自动化涂装系统
下一篇:工业涂装流水线主要的用途是什么?