山东创杰智慧装备科技有限公司

18563723072
0534-5670558

山东创杰智慧快速发展,业绩突出,涉及煤矿机械、石油机械、工程机械、化工机械、压力容器、风电、核电、专用车、汽车、客车、造船行业等,近年来在新能源客车喷粉领域取得优异的成绩

查看更多+

 公司团队专注于整厂表面处理、涂装、环保设备的研发,如喷漆房、烘干房、打磨房、喷砂房、抛丸房、焊烟除尘设备、铸造除尘除废气设备、布袋除尘器、滤筒除尘器、旋风除尘器、VOCs废气处理设备、沸石转轮+RCO、沸石转轮+RTO、活性炭吸附脱附+催化燃烧设备、喷漆线、喷粉线、电泳线、前处理线、涂装线、自动涂装线等环保设备交钥匙工程。

查看更多+
RTO废气处理的工艺要注意什么?
来源:https://www.sdcjtz.com/ 发布时间:2023-10-09
把有机废气加热升温至800℃,使废气中的VOC氧化分解,成为无害的CO2和H2O;氧化时的高温气体的热量被蓄热体“贮存”起来,用于预热新进入的有机废气,从而节省升温所需要的燃料消耗,降低运行成本。
Heat the organic waste gas to 800 ℃ to oxidize and decompose the VOC in the waste gas into harmless CO2 and H2O; The heat of the high-temperature gas during oxidation is "stored" by the heat storage body for preheating the newly entered organic waste gas, thereby saving fuel consumption required for heating and reducing operating costs.
1、有机废气经高压引风机进入蓄热室1的保留了上一循环热量的陶瓷介质层后,陶瓷释放热量,温度降低,而有机废气吸收热量,温度升高。废气离开蓄热室后,以较高的温度进入燃烧室,准备进行氧化。
1. After the organic waste gas enters the ceramic medium layer in the heat storage chamber 1 through a high-pressure induced draft fan, which retains the heat of the previous cycle, the ceramic releases heat and the temperature decreases, while the organic waste gas absorbs heat and the temperature increases. After leaving the heat storage chamber, the exhaust gas enters the combustion chamber at a higher temperature and is ready for oxidation.
2、在燃烧室中,有机废气再由燃烧器加热燃烧,加热升温至设定的氧化温度,此时温度为设定的800℃,使有机物被分解成二氧化碳和水。由于废气已在蓄热室1内进行过预热,燃烧器的燃料用量大为减少。
2. In the combustion chamber, the organic waste gas is then heated and burned by the burner, heated to the set oxidation temperature, at which point the temperature is set at 800 ℃, causing the organic matter to be decomposed into carbon dioxide and water. Due to the preheating of the exhaust gas in regenerative chamber 1, the fuel consumption of the burner has been greatly reduced.
RTO废气处理设备
3、废气流经蓄热室1升温后进入氧化室焚烧,成为净化后的高温气体后离开氧化室,进入在上一循环已冷却的蓄热室2。在此气体释放热量,降温后排出,而蓄热室2吸收大量热量后升温,其吸收的热量用于下一个循环加热废气。在此同时,废气引风机经由反吹风管,从蓄热室3抽出少许前一循环残留在其中的微量有机气体,回送至废气风机进口处,再送入燃烧室中进行焚烧,此部分气体同处理后气体一起离开蓄热室2,经热回收设备排入大气。
3. The exhaust gas flows through the heat storage chamber 1 and is heated before entering the oxidation chamber for incineration, becoming a purified high-temperature gas before leaving the oxidation chamber and entering the previously cooled heat storage chamber 2. Here, the gas releases heat, which is cooled and discharged, while the heat storage chamber 2 absorbs a large amount of heat and heats up. The heat absorbed by it is used to heat the exhaust gas in the next cycle. At the same time, the exhaust gas induced draft fan extracts a small amount of organic gas remaining in the previous cycle from the heat storage chamber 3 through a reverse blowing duct, returns it to the inlet of the exhaust gas fan, and then sends it to the combustion chamber for incineration. This part of gas, along with the processed gas, leaves the heat storage chamber 2 and is discharged into the atmosphere through a heat recovery device.
4、在燃烧室中,有机废气再由燃烧器加热燃烧,加热升温至设定的氧化温度,此时温度同样为设定的800℃,使有机物被分解成二氧化碳和水。由蓄热室3排出。
4. In the combustion chamber, the organic waste gas is heated and burned by the burner, heating it up to the set oxidation temperature. At this time, the temperature is also set at 800 ℃, causing the organic matter to be decomposed into carbon dioxide and water. Discharged from regenerative chamber 3.
5、在此同时,由废气引风机抽出少许前一循环残留在蓄热室1中的微量有机气体,再送至燃烧室中进行焚烧,此部分气体同处理后气体一起离开蓄热室3,经热回收设备排入大气。如此交替循环。
5. At the same time, a small amount of residual organic gas from the previous cycle in the heat storage chamber 1 is extracted by the exhaust gas induced draft fan, and then sent to the combustion chamber for incineration. This gas, along with the treated gas, leaves the heat storage chamber 3 and is discharged into the atmosphere through a heat recovery equipment. This alternating cycle.

上一篇:沸石转轮废气处理技术要注意哪些内容?
下一篇:活性炭吸附设备效果下降的原因有哪些?

  • 服务热线: 18563723072
  • 官方微信